PLITSTR77 REV. C 9/12/11 INSTALLATION AND INSTRUCTION MANUAL DL15DL15DL15DL15----30W30W30W30W LED TRAFFIC DIRECTOR and WARNING STICK
-7- Operation SP1515-TDC or Standard Switch Operation Important: This product is used to direct traffic. Improper use may result in vehicular colli
-8- Optional TD77-2 Controller TD77-2 (Optional Controller w/LED Display) You may choose to control your DL15-30W with the optional TD77-2 controller
-9- TD77-2 Jumper Setting for use with the DL15-30W 1. Locate the “Option” jumper location near the center of the board. (See diagram below). (O
-10- Connection of the DL15-30W wires to the TD77-2 1 2 3 4 5 6 7 8 9 10 11 12WHITEGREENVIOLETYELLOWEMPTYEMPTYEMPTYEMPTYBLACKREDGROUND+12 VDCCONTROL W
-11- TD77-2 Operation TD77-2 (Optional Controller w/LED Display) On/Off Use the red rocker switch (located on the left side of the front panel of the
-12- TD77-2 Pattern Display LEDs The four left most LEDs of the LED display on the front of the controller will mimic the output of the stick (LEFT,
-13- (Optional TDC850 Controller CONT’D) TDC850 Option Jumpers TDC850 Control Box Cover Removal 1. Remove the four recessed Philip head screws (tw
-14- (Optional TDC850 Controller CONT’D) 6. OPTIONAL: There are two other jumpers that can be used when connecting other brand lightsticks that have
-15- A telephone style cable splitter is provided with the siren. Follow the instructions included with your siren for proper connection of the siren
-16- After the light is securely installed, loosen the adjusting screws located on each end of your light. Tilt the light to the desired angle and ti
-i- Please Note: These instructions are provided as a general guideline only. Some vehicles may require special mounting, wiring, and/or
-17- If you have any questions concerning this or any other product, please contact our Customer Service Department at (585) 226-9787. If a product
-ii- NOTICE Due to continuous product improvements, we must reserve the right to change any specifications and information, contained i
-1- Preparation Before beginning the installation: • Determine where the Traffic Director is to be mounted. • Check to see that there are no obstr
-2- Mounting It is the owners sole responsibility to ensure that the mount is secure and will not come loose while the vehicle is in motion. 1. Selec
-3- 5. You must then install the enclosed tether cords, which will help secure the light in case of impact. Attach one tether to each leg as pictur
-4- Electrical Connections The DL15-30W comes with a 15' six-conductor cable. The six wires perform the following functions: Black Wire (18AWG
-5- Optional Pattern Selection Pattern Selection for the DL15-30W when Using the SP1515-TDC (or User Supplied Switches) After your light and switch
-6- GREEN = RightPURPLE = C-OYELLOW = LeftRED = PWRBLACK = GroundWHITE = Pattern SelectIf you do not wish to change the Warning Pattern, skip to the O
Comments to this Manuals