Star-headlight-lantern 63 Series Staralarms User Manual download pdf

PLIT420 REV. B 11/6/13

4.3000

w/o Grommet

5.350

w/ Grommet

4" Round Back up Alarm

Requires 4 1/2" diameter hole and 1 3/4" clearance behind.

63 SERIES BACK-UP ALARMS

1. CAUTION: All of our DC powered back-up alarms are polarity sensitive. All wires

connected to the positive terminal of the battery should be fused at the battery for their

rated load. Testing the alarm before this fuse is properly installed will void the

warranty on the alarm.

2. Mount the alarm in the rear of the vehicle with the sound opening outward towards the

hazard zone. This alarm is designed to mount in a standard 4½ “ mounting hole.

3. Connect the black wire to the negative side of the battery or a good chassis ground.

4. Connect the red wire to an independent actuating switch or splice it into the back-up lights.

Please Note: The vehicles supply voltage must be the same as the voltage rating

specified on the alarm you are installing. Any other voltage applied will void the warranty.

5. For models with a 3-Wire Cable: The white wire is used for an alternate output. Connect

it to the positive side of your power through the switch that controls the alternate function.

If you have any questions concerning this or any other Star product, or need warranty

service, please contact our Customer Service Department at (585) 226-9787.

ONE YEAR LIMITED WARRANTY

The manufacturer warrants each new product, under normal use, against factory defects in material

and workmanship for one year after the date of purchase. The owner will be responsible for returning

to the Service Center any defective item(s) with the transportation costs prepaid. The manufacturer

will, without charge, repair or replace at its option, products, or part(s), which its inspection determines

to be defective. Repaired or replacement item(s) will be returned to the purchaser with transportation

costs prepaid from the service point. A copy of the purchaser's receipt must be returned with the

defective item(s) in order to qualify for the warranty coverage.

Exclusions from this warranty include, but are not limited to, bulbs, strobe tubes, domes, and/or the

finish. This warranty shall not apply to any light, which has been altered, such that in the

manufacturer's judgment, the performance or reliability has been affected, or if any damage has

resulted from abnormal use or service. This warranty does not apply to defect or damage occurring as

a result of disaster, accident, abuse, misuse, lightning, power surges, or failure to follow instructions in

any enclosed manuals. Any damage or defects occurring as a result of any unauthorized service or

repairs by unauthorized persons shall be excluded from this warranty.

There are no warranties expressed or implied (including any warranty of merchantability or fitness),

which extend this warranty period. The loss of use of the product, loss of time, inconvenience,

commercial loss or consequential damages, including costs of any labor, are not covered. The

manufacturer reserves the right to change the design of the product without assuming any obligation

to modify any product previously manufactured.

This warranty gives you specific legal rights. You might also have additional rights which may vary from

state to state. Some states do not allow limitations on how long an implied warranty lasts. Some states

do not allow the exclusion or limitation of incidental or consequential damages. Therefore, the above

limitation(s) or exclusion(s) may not apply to you.

IMPORTANT: Please read all of the following instructions before installing

your new Star back-up alarm. This instruction sheet applies only for

installation of the models listed above on negative ground vehicles only.

CAUTION: All of our DC powered back-up alarms are polarity sensitive. All wires

connected to the positive terminal of the battery should be fused at the

battery for their rated load. Testing the alarm before this fuse is properly

installed will void the warranty on the alarm.

SPLICE THE RED WIRE FROM THE BACK-UP ALARM INTO

THE WIRE WHICH SUPPLIES POWER TO YOUR REVERSE LIGHT

PRE-EXISTING SWITCH IN VEHICLE ALREADY CONNECTED TO

REVERSE LIGHTS (OFTEN ACTIVATED BY THE GEAR SHIFTER)

REVERSE

LIGHT

BATTERY

GOOD

CHASSIS

GROUND

GOOD

CHASSIS

GROUND

BLACK

WHITE

RED

DF Models: OPTIONAL SWITCH FOR 2nd DEVICE TO ACTIVATE B-U ALARM:

CONNECT THE WHITE WIRE TO +12 VDC FOR ALTERNATE OUTPUT

GOOD

CHASSIS

GROUND

The White wire will only be present on models

with dual function capability (DF models).

Dual Tone units emit an alternating high/low tone.

Auto-Adjusting units will automatically adjust the output volume based upon the ambient noise.

63 SERIES BACK-UP ALARMS 1

Summary of Contents

Page 1 - 63 SERIES BACK-UP ALARMS

PLIT420 REV. B 11/6/13 4.3000w/o Grommet5.350w/ Grommet 4" Round Back up AlarmRequires 4 1/2" diameter hole and 1 3/4" clearance

Comments to this Manuals

No comments

Star-headlight-lantern 63 Series Staralarms User Manual

Browse online or download User Manual for Safety Star-headlight-lantern 63 Series Staralarms. Star Headlight & Lantern 63 Series Staralarms User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Safety Star-headlight-lantern 63 Series Staralarms